421.For the circuit shown above, equivalent GATE is:- (1)OR gate
- (2)NAND gate
- (3)NOT gate
- (4)AND gate
422.Identify the logic operation performed by the given circuit.- (1)NAND
- (2)NOR
- (3)OR
- (4)AND
423.Identify the operation performed by the circuit given below.- (1)AND
- (2)NOT
- (3)NAND
- (4)OR
424.Output at terminal Y of given logic circuit.- (1)1
- (2)0
- (3)Not determine
- (4)Oscillating between 0 and 1
425.The combination of the gates shown in the figure below produces [2009]- (1)NOR gate
- (2)OR gate
- (3)AND gate
- (4)XOR gate
426.The schematic symbol of light emitting diode is (LED)- (1)
- (2)
- (3)
- (4)
427.The output of following combination is same as that of- (1)AND gate
- (2)OR gate
- (3)NAND gate
- (4)NOR gate
428.The output Y of following circuit for given inputs is :- (1)Λ⋅B(A+B)
- (2)0
- (3)A⋅B
- (4)A+B
429.The given graph represents V−I characteristic for a semiconductor device. Which of the following statement is correct? [2014]- (1)It is V−I characteristic for solar cell where point A represents open circuit voltage and point B short circuit current
- (2)It is for a solar cell and points A and B represent open circuit voltage and current, respectively
- (3)It is for a photodiode and points A and B represent open circuit voltage and current, respectively
- (4)It is for an LED and points A and B represents open circuit voltage and short circuit current respectively
430.The output of an OR gate is connected to both the inputs of a NAND gate. The combination will serve as- (1)AND gate
- (2)NOT gate
- (3)NAND gate
- (4)NOR gate
431.In the circuit below, A and B represent two inputs and C represents the output, The circuit represents- (1)AND gate
- (2)NAND gate
- (3)OR gate
- (4)NOR
432.The truth table for this given circuit is :- (1)A
B Y 0 0 1 0 1 1 1 0 1 1 1 0 - (2)A
B Y 0 0 0 0 1 1 1 0 0 1 1 1 - (3)A
B Y 0 0 0 0 1 0 1 0 0 1 1 1 - (4)A
B Y 0 0 1 0 1 0 1 0 1 1 1 0
433.Identify the logic operation performed by the given circuit:- (1)AND gate
- (2)OR gate
- (3)NOR gate
- (4)NAND gate
434.The truth table of the given circuit diagram is :- (1)A
B Y 0 0 1 0 1 0 1 0 0 1 1 1 - (2)A
B Y 0 0 0 0 1 1 1 0 1 1 1 0 - (3)A
B Y 0 0 0 0 1 0 1 0 0 1 1 1 - (4)A
B Y 0 0 1 0 1 1 1 0 1 1 1 0
435.What is the output Y in the following circuit, when all the three inputs A,B,C are first 0 and then 1? [2016]- (1)1, 0
- (2)1, 1
- (3)0, 1
- (4)0, 0
436.'The output of 'NAND' gate is shown in the truthtable ( A and B are inputs, Y is output) (P) A B Y 0 0 0 0 1 1 1 0 1 1 1 1 (Q) A B Y 0 0 1 0 1 0 1 0 0 1 1 1 (R) A B Y 0 0 1 0 1 0 1 0 0 1 1 0 (S) A B Y 0 0
0 1 1 1 0 1 1 1 0- (1)P
- (2)R
- (3)Q
- (4)S
437.A logic circuit provides the output Y as per the following truth table. [NEET 2024] (A, B, Y) = (0, 1, 0), (1, 0, 1), (1, 1, 0). The expression for the output Y is- (1)A⋅B+Aˉ
- (2)A⋅Bˉ+Aˉ
- (3)Bˉ
- (4)B
438.In a Zener diode,- (1)only p-region is heavily doped
- (2)only n-region is heavily doped
- (3)Both p and n regions are heavily doped
- (4)Both p and n regions are lightly doped
439.Photodiode is a device- (1)which is always operated in reverse bias
- (2)which of always operated in forward bias
- (3)in which photo current is independent of intensity of incident radiation
- (4)which may be operated in forward or reverse bias.
440.In the given circuit, value of Y is:- (1)toggles between 0 and 1
- (2)0
- (3)will not execute
- (4)1
441.In n type semiconductor, electrons are majority charge carriers but it does not show any negative charge. The reason is- (1)mobility of electrons is extremely small
- (2)electrons are stationary
- (3)atom is electrically neutral
- (4)electrons neutralize with holes.
442.Match the List I with List II List I(A) Intrinsic Semiconductor(B) n-type Semiconductor(C) p-type Semiconductor(D) MetalsList II(I) Fermi-level near conduction band(II) Fermi-level at middle(III) Fermi-level near valence band(IV) Fermi-level inside conduction band Choose the correct answer from the options given below:- (1)(A) → I, (B) → II, (C) → III, (D) → IV
- (2)(A) → II, (B) → I, (C) → III, (D) → IV
- (3)(A) → II, (B) → III, (C) → I, (D) → IV
- (4)(A) → III, (B) → I, (C) → II, (D) → IV
443.Given below are two statements: Statement I: In a typical transistor, all three regions emitter, base and collector have same doping level. Statement II: In a transistor, collector is the thickest and base is the thinnest segment. In the light of the above statements, choose the most appropriate answer from the options given below.- (1)Both Statement I and Statement II are correct
- (2)Both Statement I and Statement II are incorrect
- (3)Statement I is incorrect but Statement II is correct
- (4)Statement I is correct but Statement II is incorrect
444.An n−p−n transistor can be considered to be equivalent to two diodes, connected. Which of the following figures is the correct one?- (1)
- (2)
- (3)
- (4)
445.Identify the solar cell characteristics from the following options :- (1)
- (2)
- (3)
- (4)
446.Constant DC voltage is required from a variable AC voltage. Which of the following is correct order of operation?- (1)Regulator, filter, rectifier
- (2)Rectifier, regulator, filter
- (3)Rectifier, filter, regulator
- (4)Filter, regulator, rectifier
447.Which of the following logic gates considered as universal?- (1)
- (2)
- (3)
- (4)
448.For a p-type semiconductor, which of the following statements is true? [NEET 2019]- (1)Holes are the majority carriers and trivalent atoms are the dopants.
- (2)Holes are the majority carriers and pentavalent atoms are the dopants.
- (3)Electrons are the majority carriers and pentavalent atoms are the dopants.
- (4)Electrons are the majority carriers and trivalent atoms are the dopants.
449.In the circuit shown here, assuming threshold voltage of diode is negligibly small, then voltage VAB is correctly represented by:- (1)VAB would be zero at all times
- (2)
- (3)
- (4)
450.The truth table for the circuit given below is:- (1)A
B Y 0 0 0 1 0 0 1 1 0 0 1 1 - (2)A
B Y 0 0 0 1 1 1 1 0 1 0 1 1 - (3)A
B Y 0 0 0 1 0 1 0 1 0 1 1 0 - (4)A
B Y 0 0 0 0 1 1 1 0 1 1 1 0
|